SawStop Jobsite Pro JSS Service Procedure

SERVICE PROCEDURE
Replacing a Jobsite Saw Belt
Applicable Model(s)
Jobsite Saw – Pro and Legacy (JSS)
Tools Needed
• #2 Phillips head screwdriver
• 5mm hex wrench
13mm wrench
•
• Blade wrenches
Part(s) or Service Kit(s) Needed
• Belt Tensioning Kit for JSS
Related Links
• SawStop Service Tip: Replace Belt for Jobsite Saw (Legacy and Pro Models)
Jobsite Saw Pro: (Part #: JSS-120A60) Manual
•
PROCEDURE SUMMARY
This procedure shows how the JSS Belt is replaced for the SawStop JSS Jobsite saws. A helper is
recommended to assist with turning over the saw.
SAFETY
WARNING: Disconnect the plug from the power source from the tool before making any adjustments,
changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting
the power tool accidentally.
WARNING: Wear gloves when handling the saw blade.
WARNING: When servicing your tool, use only replacement parts from SawStop.
WARNING: Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery handles
and grasping surfaces do not allow for safe handling and control of the tool in unexpected situations.
WARNING: Read and understand the instruction manual and all safety warnings that came with your
tool before attempting to maintain or operate the tool. Failure to follow instructions or heed warnings
may result in electric shock, fire, serious personal injury, or property damage. Save these instructions
and refer to them whenever necessary.
SawStop.com/support For questions, contact SawStop Technical Support
Phone: 503-582-9934 / Email: service@sawstop.com
091724