Download Print this page
Akuvox X937 Quick Start Manual
Akuvox X937 Quick Start Manual

Akuvox X937 Quick Start Manual

Smart intercom

Advertisement

Quick Links

X���
Before using the device, check the device model and ensure that the shipped box includes the following items:
Plastic wall anchor
X���
Wall-mounting bracket
ST�x�� crosshead screw
��-Pin cable
M�x�� crosshead screw
Allen wrench
Diode
�-Pin cable
��-Pin cable
Flush-mounting box
PS/ALS Sensor
Camera
SPK-R�
SPK-L�
SPK-R�
SPK-L�
MIC-� MIC-� MIC-� MIC-�

Advertisement

loading
Need help?

Need help?

Do you have a question about the X937 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Akuvox X937

  • Page 1 X��� Before using the device, check the device model and ensure that the shipped box includes the following items: � � Plastic wall anchor X��� Wall-mounting bracket ST�x�� crosshead screw � ��-Pin cable M�x�� crosshead screw Allen wrench Diode �-Pin cable ��-Pin cable Flush-mounting box PS/ALS Sensor...
  • Page 2 X��� �...
  • Page 3 X���...
  • Page 4 X��� Step �: Flush-mounting Box Installation �. With a flush-mounting box in the wall According to the position of the cable in the wall, dig out a square hole (height*width*depth=���*���*��mm) that can accommodate all cables. Note: The size may need to be slightly larger depending on the actual situation. Please ensure all necessary cables are inside the hole and route, or reserve conduits for required wiring.
  • Page 5 X��� �. Without a flush-mounting box in the wall According to the position of the cable in the wall, dig out a square hole (height*width*depth=��*��*��mm) that can accommodate all cables. Note: If the HDMI cable is not needed for use, the depth can be reduced to ��mm. Ensure all necessary cables are inside the opening, and pull out the required cables (or reserve a conduit for wiring).
  • Page 6 X��� Fix the wall-mounting bracket on the wall with four ST�x�� crosshead screws. Step �: Device Mounting Take out the main unit and check if the two M� set screws at the bottom are properly positioned in the screw holes. Ensure the screw bottoms are flush with or slightly protruding from the bottom surface of the main unit.
  • Page 7 X��� The installation is completed, please remove the protective film. Door Phone (third party) PoE+ PoE+ X��� X��� X��� X���...
  • Page 8 Information contained in this document is believed to be accurate and reliable at the time of printing. This document is subject to change without notice, any update to this document can be viewed on Akuvox’ s website: https://www.akuvox.com © Copyright ���� Akuvox Ltd. All rights reserved.

This manual is also suitable for:

X937a