Pioneer AVIC Z3 - Navigation System With DVD player Installation Manual page 15

Connecting the System
Extension lead (for speed signal)
Violet/white (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system
can detect whether the vehicle is moving
forwards or backwards. Connect the violet/white
lead to the lead whose voltage changes when
the shift lever is put in reverse. Unless
connected, the sensor may not detect your
vehicle traveling forward/backward properly,
and thus the position of your vehicle detected by
the sensor may be misaligned from the actual
position.
Note
When you use the ND-PG1 speed pulse
generator (sold separately), please make sure to
connect this lead. When you use a rear view
camera, please make sure to connect this lead.
Otherwise you cannot switch to rear view camera
picture.
CAUTION
Be sure to use only the supplied extension lead. Use of another
lead could cause fire, smoke and/or damage this navigation
system.
Extension lead
(for reverse signal)
Fuse resistor
5 m (16 ft. 5 in.)
Check the position of your
vehicle´s backup light (the one
that lights up when the shift lever
is in reverse [R]) and find the
backup light lead in the trunk.
The navigation unit
Power cord
Connection method
Clamp the backup
light lead.
Clamp firmly with
needle-nosed
pliers.
Section
Backup
light lead
15
En
02