Connecting Switch Cord To Motor Cord - Craftsman 22124 - Professional 10 in. Table Saw Owner's Manual

4,
5,
6,
Fold out lower and upper support arms straight, so
that the pin (G) in the upper support goes into notch
(H) of lower support and securely tighten clamp
knob.
Assemble both hinge assemblies (I) to the outfeed
table assembly (J) with four M5 x 16mm hex head
screws, M5 lock washers, M5 flat washers. Secure
the hex head screws with four M5 flat washers and
M5 hex nuts placed under the outfeed table. Do
not completely tighten hardware.
Assemble the hinges on the outfeed table to the top
of the rear rail through existing holes with four M5 x
16mm hex head screws, M5 lock washers, M5 flat
washers. Secure the hex head screws with four M5
flat washers and M5 hex nuts placed under the rear
rail. Do not completely tighten hardware.
Fig. 11-12
CONNECTING SWITCH CORD
TO MOTOR CORD
MAKE CERTAIN the table saw is disconnected from
the power source.
Fig. 12-1
7,
8,
9,
Attach upper support assembly to tab (L) under-
neath outfeed table using one M6 x 35 hex head
screw (N) and one M6 Nylok hex nut (O). Do not
completely tighten hex nut. Allow upper support to
move freely. See figure 11-12.
Tighten hardware attaching the hinges to both rear
rail and outfeed table.
Make sure the clearance miter gauge grooves (K)
in the outfeed table align with the table saw's miter
gauge grooves. Place a straight edge on the saw
table overhanging the outfeed table. Make sure the
outfeed table is level or slightly below the saw table
and securely tighten hardware attaching support
retainer to cabinet.
A
1,
2,
Place the switch cord (A) through hole (B) in front
of cabinet. See figure 12-1.
Open motor cover, plug switch cord (C) into motor
cord (D). See figure 12-2.
3. Pull slack in switch cord into the cabinet.
Fig. 12-2
/
4. Make a loop (E) from the slack of the switch cord
and place it behind cord retaining bar (F).
See figure 12-2.
23