Connecting The Motor - Craftsman 113.248212 Owner's Manual

CONNECTING THE MOTOR
1 Next, the motor cord needs to be wired into the motor
Coming from the underside of the table will be a cord
with a black, white and green wire This is the motor
cord_
i WARNING: Foryourown safety, neverplug the
saw in until all assembly steps are completed,.
2 Loosen the two screws holding the connector box
cover on the back side of the motor Swing the cover
open
3 Install the green ground wire by removing the green
grounding screw and inserting it through the round
metal terminal on the green ground wire of the motor
cord Reinstall the green screw into the hole from
which it was removed and tighten securely
WARNING: To avoid electrocution, never con-
nect but the ground wire (colored green) to the
green screw.
4. Insert terminal end of WHITE wire on spade terminal
marked T4 on the motor Push terminal firmly until
seated.
5 Insert terminal end of BLACK wire on spade terminal
marked T1 on the motor Push terminal firmly until
seated,
6 Close motor connector box being sure that power
cord is seated in the largest strain relief groove and
tighten box cover screws,
7 DO NOT plug in power cord
GREEN
BLACK W_RETO
TERMINALT1
TERMINAL
GREEN WIRE
GREEN SCREW
STRAIN RELIEF
)VE
WIRE TO
TERMINAL T4
17