Bolting Table Saw To The Floor - Craftsman 22124 - Professional 10 in. Table Saw Owner's Manual

BOLTING TABLE SAW TO THE FLOOR Figure 13A=3
MAKE CERTAIN the table saw is disconnected from
the power source.
If you wish, the table saw can be permanently mounted
to the floor. To attach to the floor, see instructions
below.
Figure 13A-1
C
A A
C
D
1. Remove the four leveling feet (A) from the table
saw (B). See Figure 13A-1.
2. Remove six Phillip head screws (C) and remove
dust spout (D) from the back of the cabinet.
Figure 13A-2
/
E
\
H
G
F
G
3. Remove four Phillip head screws (E) from the left
side of the cabinet. See figure 13A-2.
4. Open the motor cover (F) and remove the two
Phillip head screws (G) from the CRAFTSMAN
nameplate (H). NOTE: These two Phillip head
screws have hex nuts on the inside of the cabinet.
5. Remove nine Phillip head screws ([) from the right
side of the cabinet. Remove the two miter gauge
fence hooks and the side panel (J). See figure 13A-3.
Figure 13A=4
25
6. Open motor cover and remove dust chute (K).
7. Position the table saw where you want it permanent-
ly mounted.
8. Mark the floor through the holes in the four bottom
corner brackets (L).
9. Move the table saw out of the way and drill pilot
holes at the four locations marked.
10. Attach the table saw to the floor using appropriate
hardware (not included).