Figure
22=2
G
D
3,
To rotate to the next positive stop pull plunger out,
rotate miter gauge body then push plunger back in
and continue rotating miter gauge body until it stops
against next positive stop.
4.
To adjust O-degree positive stops, loosen knob, pull
out on plunger and turn miter gauge over.
5.
Loosen the lock nut (D) 3 or 4 turns. See figure 22-2.
6,
Place a square against the guide bar (E) and front
of the miter gauge body (F). Square the miter
gauge body to the guide bar and tighten knob.
See figure 22-1.
7.
Push in plunger and make adjustments to stop
screw (G) so that it touches the plunger, then tight-
en lock nut. See figure 22-2.
8.
Recheck the positive stop angle to the saw blade.
Insert the guide bar into the miter gauge groove
and slide the miter gauge up to the saw blade.
9.
To check, place a square against the saw blade
and miter gauge body. If any more adjustments are
needed repeat steps above.
10. To set both 45-degree positive stops, repeat steps
above.