Advertisement
I
r
1
3.
4.
5.
Pull the headlight out of the assembly.
Remove the wiring connector from the
headlight socket by lifting the plastic
locking tabs on the connector and
pulling it from the socket.
Check the new headlight again. The
number on
the
light must match the
number on the headlight being
replaced. The letter, "U" or "L,"
must also match.
Plug the wiring connector into the
headlight socket. Snap the locking
tabs onto the socket.
6.
7.
8.
Place the new headlight in the
headlight assembly. The socket must
be pointing in the same direction the
socket on the burned out bulb was.
Insert the tabs on the aiming ring into
the slots in the headlight assembly.
Hold the aiming ring closed, insert the
screws at the end of the ring. Tighten
the screws until the aiming ring
touches the plastic nuts on both the
top and bottom. Do not overtighten.
Do not damage the vertical aiming
bubble.
.
..
9.
Check the headlight aim indicators.
The horizontal indicator (A) should be
on
0
(zero). If the vehicle is level, the
vertical indicator (B) should also be
on 0 (zero). If the vehicle isn't level,
check the vertical aim on a level
surface as soon as you can. If either
indicator doesn't read "0," adjust the
headlight aim. See "Adjusting
Headlight Aim" in the Index.
If your vehicle is damaged in an accident
and the headlight aim seems to be
affected, see your Chevrolet dealer.
Headlights on damaged vehicles may
require recalibration of the horizontal aim
by your Chevrolet dealer.
251
Advertisement
