Labnet FastPette Pro Quick Start Manual

Pipet controller

Download this manual

Labnet FastPette

Quick Start Guide

Catalog Number: P2004

Battery Charge

Speed Setting

SPEED

Pro Pipet Controller

™

To access the Instruction Manual

(CLSLN-AN-1014DOC) scan the QR code

or visit www.labnetlink.com.

Charging stand

(sold separately,

Cat. No. SP29056)

Level (LOW-HIGH)

Click SPEED to change.

The speed can be

controlled by pressing the

trigger buttons as well.

approx. 3 hours

Need help?

Do you have a question about the FastPette Pro and is the answer not in the manual?

Page 1 Labnet FastPette Pro Pipet Controller ™ Quick Start Guide Catalog Number: P2004 To access the Instruction Manual (CLSLN-AN-1014DOC) scan the QR code or visit www.labnetlink.com. Battery Charge Charging stand (sold separately, Cat. No. SP29056) approx. 3 hours Speed Setting Level (LOW-HIGH) Click SPEED to change.
Page 2 Mode Control Click MODE to change between Gravity (drop) MODE and Blow out (arrow) mode. Aspirating and Dispensing The speed depends on how deep the button is pressed. Maintenance UV sterilization Autoclave Isopropyl alcohol Minimum ONLY distance: 50 cm 121°C for 15 min.
Page 3 Filter Replacement PTFE filter, 0.2 μm (one included, Cat. No. SP9143) PTFE filter, 0.45 μm (sold separately, Cat. No. SP9144) Storage Safety Information WARNING: Risk of injury CAUTION Risk of damage to the device or errors in pipetting of liquids. Before starting the work with the pipet controller every user should read the operating instructions carefully.
Page 4 WARNING: • During the work with the pipet controller general safety regulations regarding risks related with laboratory work should be observed. Protective clothing, goggles, and gloves should be worn. • The pipet controller shall be used only for measuring liquids in conditions specified by the manufacturer, which are limited due to the chemical and mechanical resistance of the device, as well as the user safety.

P2004