Labnet FastPette Pro Quick Start Manual page 4

WARNING:
• During the work with the pipet controller general safety regulations
regarding risks related with laboratory work should be observed. Protective
clothing, goggles, and gloves should be worn.
• The pipet controller shall be used only for measuring liquids in conditions
specified by the manufacturer, which are limited due to the chemical and
mechanical resistance of the device, as well as the user safety.
• The information and instructions provided by the manufacturers of the
reagents must be observed.
• Read the Instruction Manual before use. Improper handling of a Li-ion
battery may result in the battery catching fire, overheating, or leaking.
• Do not puncture, crush, bend or modify the battery in any way.
• Never attempt to open or modify the battery. This can cause a fire or explosion.
• Do not expose the battery to excessive heat, direct sunlight, or fire.
• Stop charging the battery if charging is not completed within the specified time.
• If there are signs of damage, swelling or leakage, stop use and contact the
manufacturer immediately.
• Do not short circuit the (+) and (-) terminals with other metals.
Equipment Disposal
According to Directive 2012/19/EU of the European Parliament and of
the Council of 4 July 2012 on waste electrical and electronic equipment
(WEEE), this product is marked with the crossed-out wheeled bin and
must not be disposed of with domestic waste.
Consequently, the buyer shall follow the instructions for reuse and
recycling of waste electronic and electrical equipment (WEEE) provided
with the products and available at www.corning.com/weee.
Warranty/Disclaimer: Unless otherwise specified, all products are for research use or general
laboratory use only. Not intended for use in diagnostic or therapeutic procedures. Not for use
in humans. For a listing of US medical devices, regulatory classifications or specific information
on claims, visit www.corning.com/resources.
For additional product or technical information, visit www.labnetlink.com or contact your local sales office
For a listing of trademarks, visit www.corning.com/trademarks. All other trademarks are the property of their respective owners.
© 2025 Corning Incorporated. All rights reserved. 3/25 CLSLN-AN-1048DOC REV1