Step 3: Prepare The Mounting Bay; Step 4: Attach Mounting Rails Or Tray (If Required) - HP C5658A - SureStore DLT 70e Tape Drive User Manual

Installing Your Internal Drive

Step 3: Prepare the Mounting Bay

Step 3: Prepare the Mounting Bay
Caution To avoid damaging the computer, ensure that it is powered off before you
a You may need a Phillips, flat-bladed or Torx screwdriver, depending on the
b Perform a normal system shutdown and turn off the computer and any
c Remove the cover from the computer.
d Remove the front cover plates from two spare, adjacent, 5¼-inch, half-

Step 4: Attach Mounting Rails or Tray (if required)

1-8
Take the following steps to install the tape drive into your computer.
install the drive.
Static electricity can damage electronic components. To equalize the
electrostatic charges, touch a bare metal part of the computer (such as the
back plate) before you remove the tape drive from its bag.
computer you have.
connected peripherals. Disconnect power cables from the outlet.
As you work inside the computer, you may have to disconnect the SCSI
cable or power cable from other devices to maneuver the new drive into
place. If you have to do this, make a note of their positions and connections
so that you can replace them correctly later.
height bays of the computer. Keep the screws for use in step 7.
If your computer requires special rails or other hardware to install the tape
drive, mount them on the tape drive in this step.
Figure 1.5 shows how to use the tray provided with internal drives.
The drives are longer than most 5½-inch devices and some cabinets are not
deep enough for the drives to be inserted fully. For these cabinets, the tray
allows the drive to be fixed so that the front protrudes slightly (position 1).
In deeper cabinets, use position 2, so that the drive is fully inserted.