Table of Contents
Advertisement
– Give the command DIAL NUMBER after the signal tone.
After giving this command, the system requests the entry of a telephone number.
The telephone number can be entered as an interconnected spoken row of digits
(complete number), in the form of order of digits (separation through a brief voice
pause) or through individually spoken digits. After each order of digits (separation
through brief voice pause) the detected digits are repeated.
The digits zero to nine are permitted. The system detects no continuous digit
combinations such as twenty-three, but only individually spoken digits (two, three).
If you enter more than 20 digits, the system announces: "The number is too long".
Additionally for international calls a Plus (+) has to be entered in front of the 20
digits.
Example when entering a telephone number
Voice command
DIAL NUMBER
e.g. ZERO SIX ZERO THREE
If no entry is put in, the following announcement is made after about 5 seconds.
FIVE SEVEN TWO
DIAL
You can interrupt the dialogue at any time by pressing the PTT button or with the
voice command CANCEL.
Repeat last call
– Press the PTT button.
– Give the command REDIAL after the signal tone.
Using the system
Safety
Announcement
"The number please".
"Zero Six Zero Three".
"Possible commands are: dial, repeat,
correct, delete or more digits".
"Five Seven Two".
"The number is being dialed".
Driving Tips
After giving this command, the last number selected via voice input is selected
again.
Example of redial
Voice command
REDIAL
You can interrupt the dialogue at any time by pressing the PTT button or with the
voice command CANCEL.
Phone voice phonebook*
Store name
– Press the PTT button.
– Give the command SAVE/STORE NAMES/NAME/NUMBER after the
signal tone.
After giving this command, the system requests the entry of a name and a tele-
phone number which should be stored in the phone voice phonebook. In the
phone voice phonebook up to 50 entries can be stored.
The telephone number can be entered as an interconnected spoken row of digits
(complete number), in the form of order of digits (separation through a brief voice
pause) or through individually spoken digits. After each order of digits (separation
through brief voice pause) the detected digits are repeated.
The digits zero to nine are permitted. The system detects no continuous digit
combinations such as twenty-three, but only individually spoken digits (two, three).
If you enter more than 20 digits, the system announces: "The number is too long".
Additionally a Plus (+) has to be entered in front of the 20 digits.
The stored entry is shown on the information display* with an asterisk in front of
the name.
For similar names additional information (e.g. first names) should be stored.
General Maintenance
Breakdown assistance
Communication
Announcement
"The number is being dialed".
Technical Data
149
Advertisement
Table of Contents
