Table of Contents
Advertisement
148
Communication
Other possible commands
Voice command
DIAL
The telephone number is selected.
In addition to the name in the phone book, which is
selected on the information display, a voice recording
STORE
is stored to select with the help of the voice com-
mands or the entered PIN code.
The entered name or the digits are repeated. Then the
REPEAT
system requests with voice response "please pro-
ceed" the entry of further digits or commands.
The entered name or the last entered order of digits is
erased. Previously entered groups of digits are
BACK
repeated. Then the system requests with voice
response "please proceed" the entry of further digits
or commands.
All entered digits are erased. Then the system
requests with voice response "The number is
DELETE
deleted. The number please" the entry of further
digits or commands.
CANCEL
The dialogue is ended.
Enter PIN code
A PIN code must be entered before operating the system.
– Press the PTT button.
– Give the command ENTER PIN/PIN CODE after the signal tone.
After this command the PIN code can be entered.
The entry of the PIN code is only possible if:
the ignition is switched on,
the mobile phone is in the mount,
Activity
the mobile phone is switched on.
The digits zero to nine are permitted. The system detects no continuous digit
combinations such as twenty-three, but only individually spoken digits (two, three).
After each order of digits (separation through brief voice pause) the detected digits
are repeated.
Notes for entering the PIN code
When entering a PIN code with more than 8 digits, the system indicates "The
PIN is too long".
When entering an incorrect PIN code, the system indicates "The PIN is incor-
rect".
If the incorrect PIN code has been entered three times consecutively, the card
is blocked. With the aid of the personal unblocking code PUK (Personal Unblock
Key), the SIM card can be unblocked. The unblocking code can only be entered
via the phone keypad and not through the voice control.
Example for entering the PIN code
Voice command
ENTER PIN/PIN CODE
e.g. ZERO ONE TWO THREE
If no entry is put in, the following announcement is made after about 5 seconds.
STORE
You can interrupt the dialogue at any time by pressing the PTT button or with the
voice command CANCEL.
Dial number
– Press the PTT button.
Announcement
"The PIN please".
"Zero One Two Three".
"Possible commands are: store, repeat,
correct, delete or more digits".
"The PIN is saved".
(end of dialogue)
Advertisement
Table of Contents
