Table of Contents
Advertisement
WARNING
Bulbs H7 and H1 are pressurised and may burst when changing the bulb
- risk of injury!
It is recommended to wear gloves and eye protection when changing a
light bulb.
Gas discharge bulbs* (xenon bulbs) operate with a high voltage, profes-
sional knowledge is required - danger to life!
Caution
Do not take hold of the glass bulb with naked fingers (even the smallest amount of
dirt reduces the working life of the light bulb). Use a clean cloth, serviette or some-
thing similar.
Note
This Owner's Manual only describes the replacement of bulbs where it is assumed
that no major complications will arise. Other light bulbs should be replaced by your
specialist garage.
Front headlight
Using the system
Safety
Fig. 241 Front headlight:
Installing the light bulbs
Driving Tips
General Maintenance
Positions of the light bulbs in the front headlight
A
- Front turn signal light
A
A
- parking lights and low beam
B
A
- main beam light
C
Removing the headlight
The headlight must be removed in order to change the light bulb of the
parking lights, low beam lights and main beam lights as well as the turn
signal lights.
Removing the headlight
– Switch the ignition and all lights off.
– Open the bonnet ⇒ page 224.
A
⇒ fig.
– Unscrew the plastic nut
A
A
– Pull the fuse
in upward direction.
B
– Pull the locking lever of the headlight as far as the stop in the direction
A
of arrow
.
1
Breakdown assistance
Fuses and light bulbs
⇒ fig.
241.
Fig. 242 Front headlight:
Installing the light bulbs
242.
Technical Data
263
Advertisement
Table of Contents
