Table of Contents
Advertisement
Instrument lighting*
You can adjust the brightness of the instrument lighting.
Instrument lighting
– Switch on the light.
– Turn the control dial
ment lighting.
For the information display* ⇒ page 26 the intensity of the lighting is automatically
set. It is only possible to adjust the instrument lighting with the control dial if the
light intensity drops below the set value of the light sensor.
Using the system
Safety
Fig. 57 Dash panel: Instru-
ment lighting
⇒ fig. 57
to the desired intensity of the instru-
Driving Tips
Headlamp range adjustment
Once the low beam is switched on you can then adapt the range of
the headlights to the load of the vehicle.
⇒ fig. 58
– Turn the control dial
so that oncoming traffic is not dazzled.
Settings
The positions correspond approximately to the following vehicle loads:
A
Front seats occupied, luggage compartment empty.
-
A
All seats occupied, luggage compartment empty.
1
A
All seats occupied, luggage compartment laden.
2
A
Driver seat occupied, luggage compartment laden.
3
Caution
Set the headlight beam adjustment in such a way as to avoid dazzling oncoming
traffic.
Note
Headlights fitted with Xenon bulbs* adapt automatically to the load and driving
state of the vehicle (e.g. accelerating, braking) when the ignition is switched on and
General Maintenance
Breakdown assistance
Lights and Visibility
Fig. 58 Dash panel: Lights
and Visibility
until you have adjusted the low beam
Technical Data
63
Advertisement
Table of Contents
