Sunsea AIoT SIMCom SIM7075G User Manual page 53

If e-DRX is supported by the network, then it can be enabled by "AT+CEDRXS" command.
NOTE
For details about "AT+CEDRXS", please refer to Document [1]
5.4 Current Consumption
The current consumption is listed in the table below.
Table 36: Current consumption on VBAT Pins (VBAT=3.8V)
GNSS
GNSS supply current
(AT+CFUN=0,without USB connection)
Idle mode
LTE supply current
(AT+CSCLK=0；AT+CFUN=1,
GNSS off, without USB connection）
Sleep mode
GSM supply current
(AT+CSCLK=1；AT+CFUN=1,
GNSS off, without USB connection）
GSM supply current
(AT+CSCLK=1；AT+CFUN=0,
GNSS off, without USB connection）
Power SavingMode
PSM supply current
e-DRX
e-DRX mode supply current
（Tested in sleep mode）
GPRSdata transmission
EGSM850(3DL,2UL)
DCS1800(3DL,2UL)
EGSM 850(1DL,4UL)
DCS1800 (1DL,4UL)
EDGEdata transmission
www.simcom.com
Tracking, typical:54mA
GSM
CAT-M1
NB1/NB2
GSM
GSM
PSM mode Typical: 9uA
@PTW=40.96s；eDRX=81.92s；DRX=2.56s
Typical:0.6mA
@PTW=25.6s；eDRX=163.84s；DRX=2.56s
Typical:0.4mA
@power class #5Typical:369mA
@power class #0Typical:274mA
@power class #5Typical:500mA
@power class #0Typical:401mA
SIM7075G User Manual V1.00
typical:12mA
typical: 18mA
typical:14mA
typical:2.1mA
typical:0.45mA
53 / 74