Summary of Contents for Dometic ZAMP SOLAR Legacy Black KIT 1024
Page 1
KIT 1024 Legacy Black 190 Watt Dual Battery Deluxe Kit [30 amp] INSTALLATION INSTRUCTIONS INSTALLATION SAFETY - Inspect the installation area for safety hazards. - Be sure to remove all metal such as rings and other jewelry. - Disconnect all power sources and ensure solar panels are completely covered by a box or blanket until installation is done.
Page 2
Set panel with feet attached on the roof to 2 inch clear area locate the best mounting position. Position panel at least 2 inches away from any other roof Example top mounting items. Mark the locations where your feet locations connect with the roof, then set the panel aside.
Using a 1-inch step bit, create the opening for the wire harness to pass through by removing the plastic “wafer” on the base of the roof cap. *There are alternative ports on the left and right sides to the interior of the cap for use in different scenarios which allow for more customization.
Page 4
B - MOUNTING WITH VHB TAPE B-08 Find an area on the roof to mount your roof cap. Drill a hole no smaller than 1/2 Inch to allow for wiring access. (Deburring the hole is recommended.) Once the hole is made, feed the wires through from the inside and secure them respectively to the positive and negative terminals housed within the roof cap.
Page 5
12 Locate the terminals on the back of your charge controller. Note all negative wires (both battery and solar) will connect to the same terminal. 13 Connecting Battery Connect the positive wires (controller to battery) from battery 1 and 2 to BT1 and BT2 terminals.
Follow your manual to set up your battery profiles. Please contact us with any questions or concerns you have. TECH SUPPORT 541-728-0924 customer.support.zampsolar@dometic.com Solar panel Roof port cap (connect wiring) House battery Charge controller Chassis battery...
Need help?
Do you have a question about the ZAMP SOLAR Legacy Black KIT 1024 and is the answer not in the manual?
Questions and answers