Advertisement
Quick Links
KIT 1023
Legacy Black 190 Watt Deluxe Kit
INSTALLATION INSTRUCTIONS
INSTALLATION SAFETY
- Inspect the installation area for safety hazards.
- Be sure to remove all metal such as rings and other jewelry.
- Disconnect all power sources and ensure solar panels are completely covered by a
box or blanket until installation is done.
INSTALLATION TOOLS
- Phillips Head Screwdriver
- Drill
- 7/16" Wrench
- 1" Step Drill Bit
- 3/16" Drill Bit
Top of Panel
Solar Panel Frame
T-Nut
Bottom of Panel
T-nut
01 Insert each of the four T-nuts to
the omni-mount channel where you
want to install your mounting feet.
*one T-nut per mounting foot
02 Attach mounting feet to
panels using the T-nuts provided.
Use the image at left for reference.
Repeat the process four times on
Mounting
each panel.
Foot
See next step for optimum
placement.
1
Advertisement
Related Manuals for Dometic ZAMP SOLAR Legacy Black KIT 1023
Summary of Contents for Dometic ZAMP SOLAR Legacy Black KIT 1023
- Page 1 KIT 1023 Legacy Black 190 Watt Deluxe Kit INSTALLATION INSTRUCTIONS INSTALLATION SAFETY - Inspect the installation area for safety hazards. - Be sure to remove all metal such as rings and other jewelry. - Disconnect all power sources and ensure solar panels are completely covered by a box or blanket until installation is done.
- Page 2 Set panel with feet attached on the roof to 2 inch clear area locate the best mounting position. Position Example top panel at least 2 inches away from any other roof mounting locations items. Mark the locations where your feet connect with the roof, then set the panel aside.
-
Page 3: Mounting Instructions
Using a 1-inch step bit, create the opening for the wire harness to pass through by removing the plastic “wafer” on the base of the roof cap. *There are alternative ports on the left and right sides to the interior of the cap for use in different scenarios which allow for more customization. - Page 4 B - MOUNTING WITH VHB TAPE B-08 Find an area on the roof to mount your roof cap. Drill a hole no smaller than 1/2 Inch to allow for wiring access. (Deburring the hole is recommended.) Once the hole is made, feed the wires through from the inside and secure them respectively to the positive and negative terminals housed within the roof cap.
- Page 5 12 Locate the terminals on the back of your charge controller. 13 Connecting Battery Connect the negative and positive wires (controller to battery) to the corresponding terminals on the back of your charge controller labeled “battery” using a Phillips head screwdriver.
-
Page 6: Tech Support
Follow your manual to set up your battery profiles. Please contact us with any questions or concerns you have. TECH SUPPORT 541-728-0924 customer.support.zampsolar@dometic.com Solar panel Roof port cap (connect wiring) House battery Charge controller System Diagram...
Need help?
Do you have a question about the ZAMP SOLAR Legacy Black KIT 1023 and is the answer not in the manual?
Questions and answers