Advertisement
Quick Links
KIT 1027
Legacy Black 760 Watt Deluxe Kit
INSTALLATION INSTRUCTIONS
INSTALLATION SAFETY
- Inspect the installation area for safety hazards.
- Be sure to remove all metal such as rings and other jewelry.
- Disconnect all power sources and ensure solar panels are completely covered by a
box or blanket until installation is done.
INSTALLATION TOOLS
- Phillips Head Screwdriver
- Flat Head Screwdriver
- Drill
- 7/16" Wrench
- 1" Step Drill Bit
- 3/16" Drill Bit
Top of Panel
Solar Panel Frame
T-Nut
Bottom of Panel
T-nut
01 For each panel, insert each of the
four T-nuts to the omni-mount
channel where you want to install
your mounting feet.
*one T-nut per mounting foot
02 Attach mounting feet to
panels using the T-nuts provided.
Use the image at left for reference.
Repeat the process four times on
Mounting
each panel.
Foot
See next step for optimum
placement.
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Dometic ZAMP SOLAR Legacy Black KIT 1027
Summary of Contents for Dometic ZAMP SOLAR Legacy Black KIT 1027
- Page 1 KIT 1027 Legacy Black 760 Watt Deluxe Kit INSTALLATION INSTRUCTIONS INSTALLATION SAFETY - Inspect the installation area for safety hazards. - Be sure to remove all metal such as rings and other jewelry. - Disconnect all power sources and ensure solar panels are completely covered by a box or blanket until installation is done.
- Page 2 Set panels with feet attached on the roof to 2 inch clear area locate the best mounting position. Position Example top panel at least 2 inches away from any other roof mounting locations items. Mark the locations where your feet connect with the roof, then set the panel aside.
-
Page 3: Mounting Instructions
Using a 1-inch step bit, create the opening for the wire harness to pass through by removing the plastic “wafer” on the base of the roof cap. *There are alternative ports on the left and right sides to the interior of the cap for use in different scenarios which allow for more customization. - Page 4 B - MOUNTING WITH VHB TAPE B-08 Find an area on the roof to mount your roof cap. Drill a hole no smaller than 1/2 Inch to allow for wiring access. (Deburring the hole is recommended.) Once the hole is made, feed the included 10’ wire harness through from the inside and secure respectively to the positive and negative terminals housed within the roof cap.
- Page 5 12 Locate the terminals on the bottom of your charge controller. 13 Connecting Battery Connect the negative and positive wires (controller to battery) to the corresponding terminals on the bottom of your charge controller (with the battery icon) using a flat head screwdriver.
- Page 6 16 Attach the fuse block assembly to the positive terminal on the battery. Place the fuse block on the terminal and slide the flat washer over the post. Slide the positive wire from the controller over the post on top of the washer.
- Page 7 17 Connecting Solar Connect the positive and negative wires (roof cap to controller) to the corresponding terminal on the back of your charge controller labeled REMOTE “solar”. 18 Screw mounting holes into the wall until fully mounted and secured. 19 Combine two panels using the Y cable to connect each lead wire coming from the panels.
-
Page 8: Tech Support
Follow your manual to set up your battery profiles. Please contact us with any questions or concerns you have. TECH SUPPORT 541-728-0924 customer.support.zampsolar@dometic.com Solar panels System Diagram You are ready to hit the road! Roof port cap (connect wiring) House battery...
Need help?
Do you have a question about the ZAMP SOLAR Legacy Black KIT 1027 and is the answer not in the manual?
Questions and answers