Operation - Icom IC-25A Instruction Manual

2. Set the VFO MEMORY CHANNEL Switch in the position written with your favorite fre-
quency, and push VFO/MEMORY CHANNEL Switch, and the set then receives on the
memory channel.
4. If the set is turned to transmit mode, during the priority function, the transmit frequency will
be the VFO frequency in SIMPLEX mode, or its OFFSET frequency in DUPLEX mode.
When returned to receive mode, the priority function will be continued.
5. If you wish to stop the priority function, push the PRIORITY button again, and the
PRIORITY indicator is turned OFF and the operating frequency goes to the priority channel's
frequency.
6. If you wish to continue the operation on the VFO frequency, set the VFO/MEMORY CHAN-
NEL Switch to the VFO position.
1 Second 1 Second | 1 Second
5 Seconds 5Seconds 5 Seconds 5 Seconds
VFO Frequency | | | | | | | |
| 4 )
PRIORITY Frequency Transmit pRioRITY SW PRORITY SW
(Memory Channel) | ризћед pushed
(turned OFF) (turned ON)
OPERATION
1. RECEIVING |
After connecting an antenna, microphone, етс., set knobs and switches as follows.
VFO/MEMORY CHANNEL SWITCH "VFO"
VFO SWITCH "A" (out)
VOLUME CONTROL and POWER SWITCH Completely counterclockwise (OFF position)
SQUELCH CONTROL and RF POWER SWITCH
| Completely counterclockwise (Pull switch is normal position.)
SIMPLEX/DUPLEX SWITCH "SIMP" (out)
DUPLEX MODE SWITCH "NOR" (out)
OFFSET SWITCH (1С-2БА only) "—" (in)
The other switches are unrelated to receiving and need not be set at this time.
4g