GE NetworX Series User Manual page 8

Home mode allows you to temporarily exclude some rooms from security arming. For
example, you may wish to exclude bedrooms at night when they are in use. Home mode is
also used for protecting exterior doors and windows (the home perimeter) when the user is
inside.
Partial is used when the user is inside the premise and wants protection around the perimeter.
Listed below are the steps to arm in the Partial mode:
1. Close all protected doors and windows. Ready light will light when all protected zones and
sensors are secure. Note: If any zones are bypassed, a sensor in that zone can be violated
without affecting the ready light. The security system will not arm if the ready light is not on. If
the power light is off, you have no AC power. Restore power if possible. If not, contact your
security installation company.
2. Press the [Partial] key. The bypass light will illuminate if any zone(s) is bypassed. The
light(s) corresponding to the bypassed zone(s) will illuminate, alerting the user that a zone(s)
may be unprotected and can be faulted without an alarm.
Key Sequence
Disarming – From the On or Partial mode
When you enter the protected area through one of the designated Entry/Exit doors, the code
pad control will sound a solid continuous tone for the duration of the entry delay time, or until
you enter a valid code. After entering a valid code the red armed light will go off and the tone
will stop. The security system is now Disarmed. If a valid code is not entered before the end
of the entry delay, an alarm will occur. (Note: If the red armed light is flashing during the entry
delay, the alarm system has been activated in your absence. Leave the building immediately
and call your alarm company and/or the police from a safe location.)
Key Sequence
NX alarm system user's manual
Partially Arming the system
– Partial or Home mode
Operation
Press the Partial key to partially
arm your premises.
Operation
Enter your user code to disarm the
system from the On or Partial
mode.
Page 6