GE NetworX Series User Manual page 4

Glossary of Terms
Abort Delay: An option that allows a delay in reporting to the central station.
Authority Level: The level of access an individual has when using an alarm panel.
Central Station: Location where alarm data is sent during an alarm report.
Chime Feature: An option that allows the code pad to sound a ding-dong whenever an
entry/exit door is opened.
Codes: Can be either User Codes (relating to a person) or Function Codes (a toggle
switch to turn specific functions on/off).
Note: A system may have either 99 four (4) digit codes or 66 six (6) digit codes, but not
a mixture of the two.
Duress Code: An option that allows a special code to be sent to the central station that
indicates the alarm system is being operated under duress.
Forced Arming: An option that allows the system to be turned on (Armed) with one or
more zones open. A system that is ready to be 'force armed' will flash the ready light.
(Note: Those zones that are not ready will not create an alarm.)
Function Code: A Function Code is either a four (4) or six (6) digit code that has been
programmed by the installer to operate a system device.
Group Bypass: An option that allows the user to bypass multiple zones with a single
operation.
Master Code: A master PIN code that can arm & disarm the alarm system, and can add
and delete user PIN codes.
Multi Area System: A system divided into multiple areas in which a user or users control
one or more areas.
Partial Arm: A mode used to arm the perimeter and unused areas of an occupied
premises.
Perimeter: The outer edge of the protected area, typically the windows and doors fitted
with alarm sensors
Quick Arm: An option that allows you to turn on (arm) the security system by pressing
either the [On] or [Partial] key on the code pad control (for arming only) as programmed
by the security installation company.
Universal Arming (Uni Arm): When enabled, your alarm system can automatically
determine whether to arm in the Full mode or in the pre-set Partial mode by detecting if
you exit your premises or stay inside after arming your system.
Note: This feature can be used in conjunction with 'Quick Arm'.
User Code: A four (4) or six (6) digit entry used to arm or disarm the alarm system.
NX alarm system user's manual Page 2