Table of Contents
Advertisement
VIVOTEK
Waterproof Connector
Components of the Waterproof Connector
Rubber (A)
Screw Nut (B)
Seal (C)
Assembling Steps
1� Disassemble the components of the waterproof connector into part (A) ~ (F) as shown above�
2� Remove the rubber stopper from the bottom of the Network Camera and secure the rubber (A)
and screw nut (B) tightly�
3� Open the back cover of the Network Camera�
4� If you have external devices such as sensors and alarms, feed the cables through the
waterproof connector (F --> E --> C --> A+B) as the illustration shown below� Then refer to
the pin definition to connect them to the general I/O terminal block. Note: The recommended
cable gauge is 2�0 ~ 2�8 mm�
5� Push the seal (C) into the housing (E)�
6� Insert the seals (D) into the empty holes on the seal (C) to avoid moisture�
7� Secure the sealing nut (F) tightly�
8� Tighten the back cover�
9� Remove rubber (G) and feed the cables through the wall mount bracket�
(C)
5
8 - User's Manual
Seals (D)
Housing (E)
Sealing Nut (F)
2
3
(A)+(B)
(C)
(E)
(F)
(E)
(F)
4
IO Block Pin Definitions
1
2
3
4
5
6
7
8
9
10
6
(C)
(D)
1
Power +12V
2
Digital Output
3
Digital Input
4
Ground
5
RS485 +
6
RS485 -
7
Ground
8
Audio Input
9
Ground
10 Audio Output
(F)
7
8
(G)
9
Advertisement
Table of Contents
