HP 914c - iPAQ Business Messenger Smartphone Navigation Manual page 48

The content of the Cursor menu depends on the screen (Map or Cockpit) and it is
slightly different if there is an active route already planned. You have the following
options:
• Start: use the Cursor as the departure point for your route. This menu point is
available only in Map mode and when there is no active route. In Cockpit mode the
departure point of the route is always the GPS position or if it is not available, the
last known GPS position.
• Route To: use the Cursor as the destination of your route. This button is to start a
new route. The previous route (if it exists) will be deleted and replaced. If a multi-
point route is active, HP iPAQ Trip Guide will ask you whether you really want to
delete it together with all its via points.
• Add Via: by inserting the selected map point as a via, you instruct HP iPAQ Trip
Guide to cross this location before the destination of the route. This is the way to
build a multi-point route in reverse order (when you wish to insert a stopover 'go to
A but first get some fuel at B' or want to influence the direction of the route). This
menu point works only if a route is already active.
• Remove Via: removes the 'via point' near or at the Cursor. The route will be
recalculated immediately excluding the deleted point. This menu point replaces Add
Via and is available only if the Cursor is near or at a via point.
• Continue: add a new destination to be reached after the previous destination. The
new destination replaces the old one, which is now demoted to a via point. This is
the way to build your multi-point route in straight order (when you wish to visit
several destinations 'go to A then to B'). This menu point is available only if a route
is already active.
• Pin: push a coloured pin in the map at the selected point for later use. This pin is
visible at all zoom levels and also appears in the History list together with its exact
position. The colour of the pin is automatically selected by HP iPAQ Trip Guide.
• Unpin: remove the pin near or at the Cursor. This menu point replaces Pin and is
available only if the selected point is near or at a pin.
• POI: opens the list of POIs near the selected point. These are the POIs shown in the
Popup Info window. This menu point is only available on the Map screen. If you
want to add a new POI at the cursor, you can do so by tapping Add POI in the
bottom left corner. You can also add a new road safety camera if you tap Add
Cam, and set the parameters (type, direction, and speed). If a camera already
exists near the cursor, this button is inactive, and you can change the parameters of
the camera by tapping it in the list.
48