List Selectors; Sliders; Switches - HP 914c - iPAQ Business Messenger Smartphone Navigation Manual

List selectors

When the values in the list need to be named, only the current value is shown
(sometimes together with a short description) in a horizontal stripe with arrows at both
ends.
The arrows are buttons. Tap to move left in the list or tap to move right.
You need not confirm your selection. As soon as you leave the screen, the selected
value becomes effective.

Sliders

When a feature has several different unnamed (numeric) values, HP iPAQ Trip Guide
will show sliders that look like analogue potentiometers to set the desired value.
If the value limits are not displayed at the ends of the slider, the leftmost position
means the minimum value, while the rightmost position represents the maximum value.
With most sliders you can check the current value on the left.
This control can be operated in two ways. Either drag the handle to move the slider to
its new position, or tap the slider where you want the handle to appear (the thumb
jumps there immediately). As with the list selectors, there is no need to confirm your
selection. As soon as you leave the screen, the selected value becomes effective.

Switches

When a function can only have two values (mainly Enabled and Disabled), a switch is
used. Unlike with list selectors, the horizontal line contains the name of the function
and not the actual status. There is a lamp on the left to show whether the function is
active or not.
18