Vektek Guardian 2.0 User Manual page 30

Vektek Guardian™ 2.0 User's Guide
Wake a Pallet
If a Pallet has been "Stored" in the MCU memory, it can be restored by "Waking" it up. To wake a pallet:
1. Press the arrow key by "Wake" from the Pallet Menu. This brings you to the "Wake Pal" menu.
Press the arrow key next to the pallet you want "Woken" and the system will communicate with
the FTU waking it up. The pallet is now ready for standard service again.
Store a Pallet
If you would like a pallet taken out of standard service and removed from the home screen but want it
saved for future use, the option exists to "Store" a pallet in the MCU memory.
1. Press the arrow key by "Store" from the pallet Menu. This brings you to the "Store Pallet" menu.
Press the arrow key next to the pallet you want "Stored" and the system will communicate with
the FTU and place the Pallet in "Storage". You can undo this action by following the "Wake a
Pallet" procedures
G e n e r a l P r o d u c t R e v . A I A W E C N - 5 5 8 1
© Copyright 2025 by Vektek, LLC
@ Copyright 1986-2025 by Vektek LLC****
Figure 44: SCREEN: WAKE PAL MENU
Figure 45: SCREEN: STORE PAL MENU
********** ****See Vektek.com>Products>Maintenance
P a g e | 30 of 44