Vektek Guardian 2.0 User Manual page 28

Vektek Guardian™ 2.0 User's Guide
Adding a New Pallet
1. Start by pressing the arrow by "Setup" in the screen above
2. If setting up with a Pallet ID Tag. Make sure the ID tag is within line of sight of the Pallet ID
Reader and press Scan. The screen will then briefly show the Pallet ID Tag information and will
begin searching for the FTU. At this point it is important that you are holding the magnetic pen
over the light on the FTU so that the light is shining constantly. Keep the magnetic pen there
until pairing is successful.
G e n e r a l P r o d u c t R e v . A I A W E C N - 5 5 8 1
© Copyright 2025 by Vektek, LLC
@ Copyright 1986-2025 by Vektek LLC****
Figure 38: SCREEN: SETUP MENU
Figure 39: SCREEN: "SCANNING"
Figure 40: SCREEN: "SCANNED ID"
********** ****See Vektek.com>Products>Maintenance
P a g e | 28 of 44