If problem could not be resolved, please contact with your dealer. Use only DJPOWER high-quality PRO-A or PRO-D fog liquid Never drink liquid. If it is ingested, call a doctor immediately for any discomfort. If liquid comes in ...
2 INTRODUCTION Product Description As a small size high-end fog machine, H-6 equips with "Immediate-Stop" patented technology, electronic temperature control system, high precision temperature control PCB and brand new professional fog generator. Built-in LCD control panel enable timing and quantitative work, adjustable fog output.
Product Dimensions 3 TECHNICAL SPECIFICATIONS Input Voltage & Rate AC 220-240 V, 50/60 Hz AC Power Current Limiter Specifications 8 A/250 V Total Power Consumption 1,500 W Heating Heat Up Time 4 min Capacity Tank Capacity Output 20,000 cuft/min Output: Fluid Consumption Rate 10 min/L Max Output Distance...
Installation 1、After ensuring all the accessories are intact, position the machine on a flat surface, and open the cover of the road case in front. 2、Press the oil tank’s quick connector by thumb and forefinger, and take it out quickly to disconnect the tube and the oil tank.
Press ON button to run the unit or OFF button to stop it. When the machine is under wireless remote control, the haze output is the one set by VOLUME OUT. For example, if the VOLUME OUT is 1%, then it will be 1% when controlled by wireless remote. Note: 1.
5 TECHNICAL INFORMATION Service and Manintenance 1、Please use DJPOWER fluid. It will prolong the lifetime of machines. To avoid danger, it is not allowed to take machine apart by unprofessional man. Neither to refit the machine. 2、Excessive dust, fluid residue and dirt will degrade performance and cause overheating. Remove dust from air vents with air compressor, vacuum or a soft brush.
Page 9
6 FOG MACHINE FLUID BLOWOUT AND HEATER BLOCKING PHENOMENON ANALYSIS Please use the original consumables, protect your health and life of machine A. Fluid injection trouble: Refers to the fog fluid atomizing in the heater pipe of the machine is not good, heater temperature cannot be timely and effective transmit to the fog fluid, fog fluid cannot atomization and lead to fluid injection.
Need help?
Do you have a question about the H-6 and is the answer not in the manual?
Questions and answers