Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for djpower djv DF-V9C
Summary of Contents for djpower djv DF-V9C
-
Page 2: Safety Information
3. Microcomputer electronic temperature control to support constant temperature, after first time heat up, available for output at any time; 4. Optional wireless remote controller W-2; 5. Please use DJPOWER professional fog fluid, other consumables might cause fluid splash or clogging! Safety information ... -
Page 3: What Is Included
11. cut off the power, and check the fog liquid amount, fuse, power cable and power plug. If problem could not be resolved, please contact with your dealer. 12. Use only DJPOWER high-quality DJ fog liquid. 13. Never drink liquid. If it is ingested, call a doctor immediately for any discomfort. If liquid comes in contact with skin or eyes, rinse thoroughly with water. - Page 4 Wireless Controller(W-2) selected This mode will allow you to control the fogger using the optional wireless controller. This consists of the transmitter and the receiver. You may control up to 4 independent fog machines, or many more if you run them simultaneously.
-
Page 5: Service And Maintenance
Service and Maintenance 1. Please use DJPOWER fluid. It will prolong the lifetime of machines. To avoid danger, it is not allowed to take machine apart by unprofessional man. Neither to refit the machine. 2. Excessive dust, fluid residue and dirt will degrade performance and cause overheating. Remove dust from air vents with air compressor, vacuum or a soft brush. -
Page 6: Technical Parameters
Technical parameters Input Voltage AC 220 V - 240 V 50/60 Hz Fuse F5 A/250 V Total Power Consumption 750 W Heat Up Time 4.5 min Max Output Volume 6,400 cuft/min Fluid Consumption Rate 31 min/L Wired Controller Wireless Control Fluid Tank Capacity 1.3 L Net Weight... - Page 7 Fog machine fluid blowout and heater blocking phenomenon analysis Please use the original consumables, protect your health and life of machine A.Fluid injection trouble: Refers to the fog fluid atomizing in the heater pipe of the machine is not good, heater temperature cannot be timely and effective transmit to the fog fluid, fog fluid cannot atomization and lead to fluid injection First reason: Using the low quality or counterfeit fog fluid, low quality fog fluid have more impurities, easy...
Need help?
Do you have a question about the djv DF-V9C and is the answer not in the manual?
Questions and answers