Anti-Tip Stability Device Installation Instructions - DeLonghi DEFSGG 24 SS Installation Instructions Manual

0 mm
0"
+ 8 mm
+ 5/16"
YOU MUST USE STABILITY
ANTI TIP BRACKET TO
PREVENT
TIPPING.
Dotted line showing the position
of the range when installed
8
LEVELLING THE RANGE
The range is equipped with 4 LEVELLING FEET and may be levelled by screwing or
unscrewing the feet with a spanner (fig. 1.8).
It is important to observe the directions of figures 1.6, 1.7a, 1.7b.
Fig. 1.6
+ 8 mm
+ 5/16"
+ 20 mm
Fig. 1.7a
+ 25/32"

ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS

1. The anti-tip bracket has to be attached as shown on figure below (only rear right
UNIT FROM
side), it has to be fixed on the floor and on the rear wall by no. 4 (four) suitable screws
(not supplied).
2. After fixing the anti-tip bracket, slide range into place. Be sure the rear right foot
slides under the anti-tip bracket attached.
Supplied with the range
in a separate kit
Fig. 1.7b
Fig. 1.9
ANTI-TIP STABILITY
DEVICE FIXING
Anti-tip stability
device
Rear right
feet of range
Fig. 1.8