Cast Tec POLARIS INTEGRA INSET ARCH ECO Installation And Operating Instructions Manual page 24

Polaris Integra Arch Eco Manual
Packaging:
•
o Your appliance is packaged to minimise exposure to adverse elements and
should reach you in perfect condition. The product should be stored in a
warm, dry environment and remain packaged until the fireplace is ready to be
installed. It is essential that you inspect your casting prior to installation as it
will be deemed to be of merchantable quality thereafter and no liability will be
accepted for product removal, reinstallation or redecoration.
Cleaning Glass:
•
o This product is equipped with an air wash for the glass. Air is sucked in
through the air vent above the fireplace and down along the inside of the
glass. However, some soot will always stick to the glass, but the quantity will
depend on the local draught conditions and adjustment of the air wash vent.
Most of the soot layer will normally be burned off when the air wash vent is
opened all the way and a fire is burning briskly in the fireplace.
o Good advice! For normal cleaning, moisten a paper towel with warm water
and add some ash from the burn chamber. Rub it over the glass and then
clean the glass with clean water. Dry well and if it is necessary to clean the
glass more thoroughly, we recommend using a glass cleaner (follow the
instructions on the bottle).
• Gaskets:
o The gaskets in the door will wear out over time and should be replaced as
required in order to prevent runaway combustion.
• Cleaning – Polished cast iron:
o After unpacking your casting, you will need to remove the protective oil
coating, which is applied to prevent tarnishing and rust, you need to wipe the
polished areas with white spirit on a cloth, repeat this procedure until the
surface is clean. Under no circumstances should a water-based cleaner
be used to clean the surface – This will make the bare cast iron tarnish
and then rust.
24
MAINTENANCE
Ref No: I17. V2.
Cast Tec Ltd