HP Remote System Controller User Manual page 25

■
After the file is in the RSC internal storage, or the streaming target has been defined, mount the
image from the file menu by toggling the Mount key.
Only one file can be mounted at a time. If a previously unmounted image is mounted and another
image was already mounted, a confirmation dialog is displayed to confirm that you want to unmount
the previous image.
The host detects that a new drive is being attached if an operating system is running. You can also target
the virtual device as a boot target, if the image is capable of being booted.
Unmounting the file
Use this procedure to unmount the file.
■ Toggle the Mount key to unmount a file.
The file is still available for mounting again.
Removing a file
Use this procedure to remove a file from the RSC storage.
■ Select the trash bin icon next to a file to either delete the file from the RSC storage, or remove the
streaming target setup. In either case, the file will be unmounted first.
Navigating and configuring BIOS settings
This section describes how to navigate and configure BIOS settings.
Accessing BIOS settings
Follow the instructions outlined here to enter the Host BIOS settings section.
1. On the left side of the dashboard, select Host.
2. Scroll down to locate the Host BIOS settings.
NOTE: The Host BIOS Settings that are displayed depend on what the host BIOS supports. HP
recommends that you update the host BIOS to the latest version to gain access to the most number of
BIOS settings.
Navigating the BIOS interface
The BIOS settings page offers an overview and several navigational tabs.
Table 3-4 BIOS settings tabs
Tab
Main
Advanced
Security
Boot Settings
Other
Description
General information about your system and basic settings
Detailed settings for your hardware components
Security features such as passwords and boot integrity settings
Configuration for boot order and other options
Additional settings not covered in the other tabs.
Unmounting the file 19