Compaq DS20E - AlphaStation - 1 GB RAM User Manual page 197

quit
The quit command exits the user from command mode and reconnects the serial
terminal to the system console port. The following message is displayed:
Focus returned to COM port
The next display depends on what the system was doing when the RCM was
invoked. For example, if the RCM was invoked from the SRM console prompt, the
console prompt will be displayed when you enter a carriage return. Or, if the RCM
was invoked from the operating system prompt, the operating system prompt will be
displayed when you enter a carriage return.
reset
The reset command requests the RCM to reset the hardware. The reset command is
equivalent to pressing the Reset button on the control panel.
RCM>reset
Focus returned to COM port
The following events occur when the reset command is executed:
The system restarts and the system console firmware reinitializes.
The console exits RCM command mode and reconnects the serial terminal to the
system COM1 serial port.
The power-up messages are displayed, and then the console prompt is displayed
or the operating system boot messages are displayed, depending on how the
startup sequence has been defined.
Managing the System Remotely 6-9