Kramer VIA GO3 Quick Start Manual page 2

Step 3: Mount VIA GO3
VIA GO3 can be installed on a flat surface / wall, rear of a monitor or rack mount using the included VESA
mounting bracket and screw set:
Mount VIA GO3 to the Mounting Bracket
Attach the mounting bracket to the VIA GO3 with 2 screws.
This step is required for all options detailed below.
To Mount to a Flat Surface /
Wall
Secure the mounting bracket to a
flat surface / wall with dedicated
screws.
Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your VIA GO3.
1. Connect a USB device.
2. Connect an HDMI display.
3. Connect to the LAN (default mode).
To use a Kramer active optical pluggable HDMI cable with your VIA GO3, contact your local Kramer
office to assist in purchasing the correct cable.
To achieve specified extension distances, use the recommended Kramer cables available at
www.kramerav.com/product/VIA GO3.
To Mount to rear of monitor
Secure the mounting bracket to
VESA holes located on rear of
monitor.
Using third-party cables may cause damage!
To Mount to a Rack Mount
Secure the mounting bracket(s) to
the rack mount with dedicated
screws.