Cisco Nexus 9364E-SG2 Hardware Installation Manual page 23

Installing the Chassis
Note
Install a Rack
Before you install the switch, you must install a standard four-post, 19-inch EIA data center rack (or a cabinet
that contains such a rack) that meets the requirements listed in
Procedure
Step 1 Bolt the rack to the concrete subfloor before moving the chassis onto it.
Warning
Statement 1048 Rack Stabilization
The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor before installation or servicing.
Failure to stabilize the rack can cause bodily injury.
Step 2 If the rack has bonded construction, connect it to the earth ground. This action enables you to easily ground the switch
and its components and to ground your electrostatic discharge (ESD) wrist strap to prevent damaging discharges when
you handle ungrounded components before installing them.
Step 3
Warning
Statement 1018 Supply Circuit
To reduce risk of electric shock and fire, take care when connecting units to the supply circuit so that wiring is not
overloaded.
Note
If you are not using power redundancy or are using n+1 redundancy, you need only one power source. If you are using
n+n redundancy, you need two power sources.
Unpacking and Inspecting a New Switch
Before you install a new chassis, unpack and inspect it to be sure that you have all the items that you ordered.
Verify that the switch was not damaged during shipment. If anything is damaged or missing, contact your
customer representative immediately.
Caution
You are responsible for verifying that your rack and rack-mount hardware comply with the guidelines that
are described in this document.
When you handle the chassis or its components, follow ESD protocol at all times to prevent ESD damage.
This protocol includes but is not limited to wearing an ESD wrist strap that you connect to the earth ground.
Cisco Nexus 9364E-SG2 (N9364E-SG2-Q) NX-OS-Mode Switch Hardware Installation Guide
Overview of Racks, on page
Install a Rack
41.
17