Danfoss TechCase iC7 Operating Manual page 7

Operating Guide | TechCase iC7
Safety
2
Target Group and Necessary Qualifications
2.1
Correct and reliable transport, storage, installation, operation, and maintenance are required for the trouble-free and safe operation
of the products. Only qualified personnel are allowed to perform all related activities for these tasks. Qualified personnel are defined
as properly trained staff, who are familiar with and authorized to install, commission, and maintain equipment, systems, and circuits in
accordance with pertinent laws and regulations. Also, the qualified personnel must be familiar with the instructions and safety measures
described in this guide and other relevant guides. Non-qualified electricians are not allowed to perform any electrical installation or
troubleshooting activities.
Only Danfoss authorized, qualified personnel are allowed to repair this equipment. Specialized training is required to perform the
activities related to repair.
Safety Symbols
2.2
The following symbols are used in Danfoss documentation.
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Indicates information considered important, but not hazard-related (for example, messages relating to property damage).
The guide also includes ISO warning symbols related to hot surfaces and burn hazard, high voltage and electrical shock, and referring to
the instructions.
ISO warning symbol for hot surfaces and burn hazard
ISO warning symbol for high voltage and electrical shock
ISO action symbol for referring to the instructions
General Safety Considerations
2.3
Danfoss Drives Oy © 2024.09
DANGER
WARNING
CAUTION
NOTICE
AQ433140445569en-000201 / 172K0364B |
Safety
7