Tektronix 2714 User Manual page 345

Frequency Response Measurement,
Frequency/Amplitude Related Char-
acteristics, 2-14
Function Blocks, 3-9
Fundamental Operations, 5-3
Channel Entry, 5-6
Frequency Entry (Non-CATV
Mode), 5-70
Frequency Entry (Normal Mode),
5-8
REF LEVEL, 5-77
SPAN/DIV, 5-3
G
General (CATV) 2714 Mode, 6-4
Channel Tables, 6-5, 6-6
Selecting a Channel Table, 6-6
Signal Types, 6-5
General Characteristics, 2-23
GPIB
Address, 4-16
Configuration, 7-77
EOI/LF MODE, 7-77
EOI/LF Mode, 4-17
GPIB ADDRESS, 7-77
POWER ON SRQ, 7-77
Power On SRQ, 4-76
STATUS, 7-77
TALK ONLY MODE, 7-72
Talk Only Mode, 4-17
GPIB Configuration, 7-77
Graticule Illumination, 4-33, 7-47
H
Headphone Jack, 3-17
Heterodyne, 7-3
Holdoff, Sweep, 7-76
Horizontal Position Adjustment, 5-40
HUM/LFD Measurement, 4-24, 6-24
Enable HUM/LFD Measurement,
6-26
Immediate Entry Mode, 4-5
In-Channel Response Measurement,
6-43
Initial Display, 3-7
Initial Normalization, 3-6
Initial Setup, 6-3
Input (INPUT) Menu, 4-34
1st Mixer Input Level Selection,
4-35
Cal Signal @100 MHz 18.8 dBmvV,
4-35
External Atten/Amp Selection,
4-35
Preamp, 4-34
Ref Level Unit, 4-34
RF Attenuation Selection, 4-35
INPUT Menu, 7-4
75/50 Ohm Matching Minimum
Loss Pad, 7-9
Accommodating a 50 Ohm
Accommodating External Amplifi-
cation/Attenuation, 7-7
Changing Reference Level Units,
Setting the First Mixer Input Level,
7-9
Setting the RF Attenuation, 7-5
Turning the Calibrator ON and
OFF, 7-5
Turning the Preamplifier ON/OFF,
7-10
Using the DBUV/M, 7-17
Input Power Limitations, 6-2