Jumper Settings
SCSI Device Jumper Settings
No two SCSI devices connected to the same SCSI controller can have the
same SCSI ID. If another SCSI device is connected to the same controller,
check its SCSI ID before beginning the installation procedure for the
additional device. The SCSI ID is set by jumpers located on each device. For
more information, refer to your SCSI device option documentation.
ATA Device Jumper Settings
When installing any ATA devices, make sure that the jumper on the device is
set to Cable Select (CS). This option allows the cable to determine which
device is the primary drive and which is the secondary drive. For information
on cabling ATA devices, see Chapter 4, "Cabling Guidelines."
LED Indicators, Switches, and Jumpers E-13