Removing The Access Panel - Compaq 234664-002 - ProLiant - ML330T02 Setup And Installation Manual

3-4 Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide

Removing the Access Panel

To remove the access panel:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed)
AC outlet before removing the access panel.
CAUTION: Do not operate the server while the access panel is removed. This
panel is an integral part of the cooling system and removing the panel while the
system is running may adversely affect data integrity.
1. Follow the procedures in "Powering Down the Server" and "Removing
the Front Bezel" earlier in this chapter.
2. Remove the screw located on the left side of the front chassis
3. Slide the access panel forward, pull from the top of the access panel, and
then lift the panel from the chassis
2
Figure 3-2. Removing the access panel
NOTE: Turn the access panel over to locate the System Configuration label. This label
provides information about the system board of the ProLiant ML330 Generation 2 server.
To replace the access panel, reverse steps 2 and 3.
.

1
.