Creating The Windows 95 Diskettes; Installing The Smart-2Dh Array Controller With Windows 95 - Compaq 219700-001 - ProLiant - 1500 Reference Manual

Access to a server or workstation with a bootable CD-ROM drive. This
may be the system in which you are installing the SMART-2DH
Controller.

Creating the Windows 95 Diskettes

To create the diskettes:
1. Boot the server from the Compaq SmartStart and Support Software
CD.
2. From the Compaq System Utilities screen, select Create Support Software.
3. From the Diskette Builder screen, select Create Support Software
Diskettes from CD only.
4. Scroll down the list and select Compaq Support Software for Windows 95.
5. Follow the instructions on the screen to create and label diskettes.
Installing the SMART-2DH Array Controller
with Windows 95
Use these basic steps to install a SMART-2DH Controller in a Windows 95
server to operate in either the SMART-2 Controller mode or the Interrupt 13h
BIOS support mode.
SMART-2 Controller Mode
To install the SMART-2DH Controller in a Windows 95 environment using
the SMART Controller mode, follow these steps:
1. Update your system firmware by running System ROMPaq.
2. Install the SMART-2DH Controller option board.
3. Configure the hardware by running the System Configuration Utility.
Be sure to set these SMART-2DH Controller parameters:
Set the Controller Order. If the SMART-2DH Controller will be
the primary disk controller set this parameter to First.
Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002
File Name: G-CH06.DOC Last Saved On: 2/27/98 12:01 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
SMART-2DH Array Controller Reference Guide
6-51