Appendix Hpost Error Messages - Compaq 219700-001 - ProLiant - 1500 Reference Manual

Appendix H
POST Error Messages
The SMART-2DH Controller produces diagnostic error messages at reboot.
Many of these Power-On Self-Test (POST) messages are self-explanatory and
suggest corrective actions for troubleshooting. Detailed information and
corrective actions are listed below.
NOTE:
internal port 1 connector. SCSI port 2 refers to external drives installed in a
Compaq ProLiant Storage System attached to the external port 2 connector.
Code
1702 SCSI Cable Error Detected. System Halted.
1720 Slot x Drive Array - S.M.A.R.T. Hard Drive
Detects Imminent Failure SCSI: Port y: SCSI
ID x.
1724 Slot x Drive Array - Physical Drive Position
Changes(s) Detected - Logical drive
configuration has automatically been
updated.
Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002
SCSI port 1 refers to internal or external drives attached to the
Table H-1
POST Error Messages
Meaning
File Name: O-APPH.DOC Last Saved On: 2/27/98 12:10 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Recommended Action
This message indicates a termination or cabling
problem with the system board integrated SCSI
controller. Refer to cabling diagrams in the
SMART-2DH Array Controller Installation Guide
for your system.
The indicated drive has reported a S.M.A.R.T.
predictive-failure condition. It may fail at some
time in the future. If this drive is part of a non-
fault-tolerant configuration, back up all data
before replacing the drive and restore all data
afterwards. If this drive is part of a fault-
tolerant configuration, do not replace this drive
unless all other drives in the array are on-line.
Select F1 key to resume.
This message indicates that logical drive
configuration has been updated automatically
following physical drive position changes.
Select F1 key to resume.
SMART-2DH Array Controller Reference Guide
H-1