Installing A Cabled Hard Drive - Dell PowerEdge R510 Hardware Owner's Manual

Figure 3-10. Removing and Installing a Cabled Hard Drive
1 hard drive
3 tab
NOTE:
If you are not replacing the hard drive, remove the drive from the drive
bracket (see Figure 3-11) and insert the empty bracket back into the drive bay.
5 Replace the system cover. See "Closing the System" on page 89.

Installing a Cabled Hard Drive

CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
2 Open the system. See "Opening the System" on page 87.
3 Remove the existing hard-drive bracket by lifting the tab on the bracket
and sliding the bracket up and out of the system.
96
Installing System Components
1
Many repairs may only be done by a certified service technician.
2
2 power/data cable
4 drive bracket
3
4