Embedded Server Management Screen - Dell PowerEdge R510 Hardware Owner's Manual

Option
Serial Port Address
(Serial Device 1=COM1,
Serial Device 2=COM2
default)
External Serial Connector
(Serial Device1 default)
Failsafe Baud Rate
(115200 default)
Remote Terminal Type
(VT100/VT220 default)
Redirection After Boot
(Enabled default)

Embedded Server Management Screen

NOTE:
This section is applicable to systems with hot-swappable hard drives only.
Option
Front Panel LCD
Options
User-Defined
LCD String
70
Using the System Setup Program and UEFI Boot Manager
Description
Sets the serial port addresses for the two serial devices.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL, configure
the same port address for console redirection and the
serial device.
Specifies whether Serial Device 1, Serial Device 2,
or Remote Access Device has access to the
external serial connector.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL,
configure the same port address for console redirection
and the serial device.
Displays the failsafe baud rate used for console
redirection. BIOS attempts to determine the baud rate
automatically. This failsafe baud rate is used only if the
attempt fails. This rate should not be adjusted.
Sets the remote console terminal type, either
VT100/VT220 or ANSI.
Enables or disables BIOS console redirection when the
operating system is loaded.
Description
Options are User Defined String, Model Number, or None.
If the LCD Home display is set to anything other than User
Defined String, Model Number, or None, this option in BIOS
will display Advanced. You will not be able to edit this setting in
BIOS until it is set back to User Defined String, Model Number,
or None through another LCD configuration utility (such as the
optional BMC or iDRAC6 Configuration Utility or LCD panel
menu).
You can enter a name or other identifier for the system, to be
displayed on the LCD module screen.