Rehau NEA SMART 2.0 End User Manual page 22

22
WIFI/LAN AP
WIFI/LAN AP
WIFI/LAN AP
3
< OK >
< 1 sec
4
WIFI/LAN AP
< OK >
< 1 sec
5
WIFI/LAN AP
05.02.02 Step 2: Establishing a connection between the master base and the PC / tablet / smartphone
WIFI
or
ON
WIFI
ON
6
Confirm by briefly pressing the OK button. The current status of the trans-
3
mitting function is displayed.
WIFI, LAN, AP: o
▪ WIFI, LAN, AP: OFF
▪ WIFI (server connection) mode
▪ AP (direct connection) mode
WIFI (server
connection) mode
AP (direct
connection) mode
By briefly pressing the < or > button, it is possible to switch between the
4
transmitting functions.
Press the < or > button repeatedly until
→ Access Point (AP) mode is preselected.
In this case, the WIFI / LAN LED flashes fast and the AP LED lights up
permanently.
Confirm by briefly pressing the OK button.
5
In this case, the WIFI / LAN LED flashes slowly and the AP LED lights up
permanently.
▪ Access Point (AP) mode is activated
▪ No device is connected with master base up to now
The NEA SMART 2.0 Base is now ready for direct connection to a PC or a
tablet / smartphone.
If no buttons are pressed for a certain time, the NEA SMART 2.0 Base will
return to the initial state. In this case, the sequence for activating the trans-
mitting function can be started again.
With the transmitting function activated, the wireless LAN (WIFI) network
transmitted by the NEA SMART 2.0 Base is visible to every user – similar to
the wireless LAN network of a router. It is recommended to change the
default password during the initial set-up. If the password has been
forgotten, it can be reset to the delivery status. See chapter 06.08.02 for
details.
On the PC / tablet / smartphone
6
▪ switch on WIFI
▪ open the WIFI menu and view the available networks
Note: The distance between the PC / tablet / smartphone should not
exceed approx. 5 m.