Rehau NEA SMART 2.0 End User Manual page 17

Display and switching of the Operation Mode
5
▪ Switching of operation mode is only available on room units which have been activated for this purpose in the installer area.
▪ Only if switching of operation mode is enabled, the +/– signs appear to allow switching.
▪ The configuration of the system and the actual conditions determine the modes of operation which may be selected by
the user.
Heating mode
automatic start
Display and switching of Energy Levels
6
▪ The energy level can be changed by pressing +/–
▪ The current operating status is always displayed first.
Normal mode
(Present mode)
Status indicator of Operation Mode
▪ The status "Heating active" and "Cooling active" is indicated by an underscore below the heating icon (wave) or cooling icon
(ice crystal).
Status indicator Fan Coil
▪ The status indicator "Fan Coil in operation" is indicated by an underscore below the fan icon.
Heating mode Cooling mode
manual automatic start
Reduced mode
(Absent manual)
Cooling mode
manual
Standby mode Automatic mode
(Timed mode)
17
6
Heating / cooling mode
automatic switching
Party mode