Sata Settings Screen; Boot Settings Screen - Dell PowerEdge E06S Series Hardware Owner's Manual

SATA Settings Screen

Option
Embedded SATA
(Off default)
Port A
(Off default)

Boot Settings Screen

Option
Boot Mode
(BIOS default)
Boot Sequence
Hard-Disk Drive
Sequence
Description
ATA Mode enables the integrated SATA controller. Off
disables the controller.
Auto enables BIOS support for the device attached to
SATA port A. Off disables BIOS support for the device.
Description
CAUTION:
the system from booting if the operating system was
not installed in the same boot mode.
If the system operating system supports Unified
Extensible Firmware Interface, you can set this option to
UEFI. Setting this field to BIOS allows compatibility
with non-UEFI operating systems.
NOTE:
Setting this field to UEFI disables the Boot
Sequence, Hard-Disk Drive Sequence, and USB Flash Drive
Emulation Type fields.
If Boot Mode is set to BIOS, this field tells the system
where the operating system files needed for startup are
located. If Boot Mode is set to UEFI, you can access the
UEFI boot manager utility by rebooting the system and
pressing <F11> when prompted to do so.
Determines the order in which the BIOS attempts to
boot from hard drives in the system during system
startup.
Using the System Setup Program and UEFI Boot Manager
Switching the boot mode could prevent
69