Dell PowerEdge E06S Series Hardware Owner's Manual page 111

NOTE:
off the system and remove all the chassis blanks. To remove the chassis blank,
press down and push the blue release tab toward the front of the system. See
Figure 3-13.
3 Press the button on the front of the drive carrier and open the handle.
4 Insert the hard-drive carrier into the drive bay until the carrier contacts
the backplane.
5 Close the handle to lock the drive in place.
Figure 3-13. Removing a Chassis Blank
1
1 chassis blank
If you are upgrading your system to a 16–hard-drive configuration, turn
2 release tab
Installing System Components
2
111