Dell PowerEdge E06S Series Hardware Owner's Manual page 121

CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 89.
3 Locate the USB connector on the system board.
4 Insert the USB memory key into the USB connector. See Figure 3-18.
5 Close the system. See "Closing the System" on page 90.
6 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
7 Enter the System Setup program and verify that the USB key has been
detected by the system. See "Using the System Setup Program and UEFI
Boot Manager" on page 63.
Installing System Components
121