Battery Charging - VTech Accessory Handset for use with the CS6319 CS6329 or CS6328 User Manual

Getting started

Battery charging

Once you have installed the battery, the screen indicates the
battery status (see the table below). If necessary, place the
handset in the telephone base or charger to charge the
battery. For best performance, keep the handset in the
telephone base or charger when not in use. The battery is fully
charged after 16 hours of continuous charging. See the table
on page 8 for battery operating times.
If the screen is blank, you need to charge the handset without
interruption for at least 10
charge to use the telephone for a short time. When the battery
is low, the handset beeps four times every minute, shows
LOW BATTerY and a flashing
in low battery mode, the handset has four short beeps to
alert you.
The following table summarizes the battery charge indicators
and actions to take.
Battery indicators
The screen is blank.
The screen shows
PLACe IN ChArGer
and flashes.
The screen shows
LOW BATTerY and
flashes. The handset
beeps four times every
minute.
The screen shows
hANDSeT X.
If you do not plug in the battery into the handset and place it in the
telephone base or charger, the screen displays NO BATTerY.
minutes to give the handset enough
icon. If you are on a call
Battery status
Battery has no
charge and the
handset cannot be
used.
Battery has very
little charge and
the handset cannot
be used.
Battery has enough
charge to be used
for a short time.
Battery is charged.
3
Action
Charge without
interruption (at least
10 minutes).
Charge without
interruption (at least
four minutes).
Charge without
interruption until
the screen shows
hANDSeT X (about
30 minutes).
To keep the battery
charged, place it in
the telephone base
or charger when not
in use.