Replace A Handset; To Reset - VTech Accessory Handset for use with the CS6319 CS6329 or CS6328 User Manual

Getting started

replace a handset

If you want to replace a handset or re-assign the designated
handset number of a registered handset, you must deregister
all the handsets and then individually register each handset.
To make deregistration easier, read all of the instructions on
this page before you begin.
To deregister all handsets:
Press and hold /FIND hANDSeT on the telephone
1.
base for about 10 seconds (until the IN USe light on the
telephone base turns on and starts to flash), then release
/FIND hANDSeT.
Press and release /FIND hANDSeT again. You must
2.
press /FIND hANDSeT while the IN USe light is still
flashing. The IN USe light flashes for approximately
seven seconds.
3. The deregistration process takes about 10 seconds to
complete. All handsets show 1.PreSS FIND hS ON BASe
4 SeC and 2.TheN PreSS # ON hANDSeT alternately
when the deregistration completes.
If deregistration fails, you may need to reset the telephone and
try again.

To reset:

1. Pick up the registered handset and then press
2. Press OFF/
telephone base.
-Or-
1. Unplug the power from the telephone base, then plug it
back in.
You cannot deregister a handset if any system handset is
in use.
and place the handset back in the
CLeAr
5
/ .
FLASh